Construction of the refrigerated

What is the refrigerator?

Nowadays, refrigerated refrigerators are made very wide. The use of Frion is done as fluid for refrigerating refrigeration cycles, which requires a low capacity refrigerator.

Freewant refrigerant in such cases is a good choice. One of the positive points is non-toxic and anti-fire alcohols.

The method of refrigerating refrigerator and in the whole refrigeration cycle is that the refrigerant will be compressed in the compressor and will result in pressure and temperature increases.

Then, the refrigerant with high pressure and gas phase enters the condenser and in the condenser is converted to liquid state and its temperature decreases, but the pressure remains constant and high after the condenser, the refrigerant enters the receiver or reservoir of the liquid collection.

In the next step, the refrigerant gets out of the receiver with a state of liquid and high pressure and reaches the Vallow X or the hair pipe.

In this section, due to the sharp drop in refrigerant pressure, it occurs in a mixture of liquid and gas powder and drows up on the surface of the evaporator and evaporated during the full steam and gas.

In this case, the evaporator has been created by the Cream, absorbs the heat of the hall and transfers outside the hall.

Refrigible refrigerator cycle:

First Stage: Compression of Fluid Fryon

Second Stage: Enter the condenser

Third Stage: Crossing Expansion Tap

Stage four: Entry to the evaporator

What is ammonia refrigerant?

The function of ammonia cold stores is somewhat similar to fronal cold stores. In this way, in Ammonia cold stores, the system has a series of devices such as compressors, condensers, tank receivers, evaporators.

But another piece that plays an important role in ammonia colds is a refrigerant pump (ammonia).

Ammonia is placed in a compressor in the compressor and enter the condenser with high pressure and temperature and is carried out in the condenser of the distillation operation and ammonia comes from gas to pure liquid.

The exhaust liquid from ammonia condenser reaches tank receiver and ammonia reservoir. But before reaching the ammonia fluid, the seas should pass from the main part called (expansion agent).

Basically, with the passage of liquid from this part, the result is the first failure of the pressure from 12 times to 2 times and the second decreases up to 10 degrees Celsius, which is mixed and powdered in this stage. Then, in ammonia seas, powder mode appears from powder mode and repeated in a cycle of these steps. The exhaust liquid from ammonia condenser reaches tank receiver and ammonia reservoir. But before the arrival of the ammonia fluid to the seas, it should pass from a main part called (expansion agent). By passing the liquid from this section, the result is the first pressure failure from 12 times to 2 times and the second decreased temperature up to 10- Celsius, which is a mixture of ammonia at this stage and powder. Then, in ammonia seas, powder mode appears from powder mode and repeated in a cycle of these steps.